 |
By *ancNickMan
over a year ago
Stockport |
Have you already had it done if not they will pierce it with a 2.4 mm ring then when goes loose round the hole stretch up is easy... Then decide if want a ring or a bar ring you want bout enough clearance to make a perfect loop hole to hole... Bar depends on length of piecing prob usually 12-16mm length wildcat is good place for rings and bars.... Also if decide on a princes wand make sure you get correct lengths |
Reply privately, Reply in forum +quote
or View forums list | |
 |
By *oodmessMan
over a year ago
yumsville |
I recently asked and its near impossible to get a size guide. I think its trial and error though I recently tried a very hard rubber one with pretty much no give.. 3 different sizes - the biggest was too lose and the smaller ones I couldnt get on.
They look good but I think it'd cost to get the one that fits right |
Reply privately, Reply in forum +quote
or View forums list | |
» Add a new message to this topic