 |
By (user no longer on site) OP
over a year ago
|
Hi everyone, ive had a few silicon cock rings in the past but have always fancied a metal one. The question I have though us how i get the right size? I have quite large bollocks (and a teeny cock lol) so am worried that i will waste money on something that doesn't fit?
Any ideas or advice? Cheers, R |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
OK, get a piece of string and measure around the base of your cock and balls, in the position of where you want your cock ring to sit.
Measure the length of the string. If you are between sizes, go up, better to be loser in the beginning untik you get used to wearing it and the weight, then you can size down when you know what is comfortable
When you look at metal rings, make sure the internal diameter is the measurement listed and not the external, and be wary of American measurements.
Also, be careful of the shape, square edged rings can pinch when you become hard and rub when you are sat down, and create a ridge under clothes when you are hard.
Dome shape rings with flat insides seem to sit better. Balls in first, then bend your cock slightly to pop through the gap.
Hope that helps  |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
Be very careful OP....I tried one a few years ago and couldn't get it off! My balls were turning purple and I was getting very very anxious.
Getting it of was a nightmare. I actually wish I had filmed it! |
Reply privately, Reply in forum +quote
or View forums list | |
"Hi everyone, ive had a few silicon cock rings in the past but have always fancied a metal one. The question I have though us how i get the right size? I have quite large bollocks (and a teeny cock lol) so am worried that i will waste money on something that doesn't fit?
Any ideas or advice? Cheers, R"
Jubilee clip - adjusts for all occasions.. |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
I use a ball stretcher, but it's worked so well I need something bigger! Concern about getting anything bigger off is on my mind as well! Take it steady  |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
I use them most of the time , its easier if you put balls through first then limp cock , they are easy to get off too , just let your cock go limp after coming , then carefully take balls out , no problem |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
"Hi everyone, ive had a few silicon cock rings in the past but have always fancied a metal one. The question I have though us how i get the right size? I have quite large bollocks (and a teeny cock lol) so am worried that i will waste money on something that doesn't fit?
Any ideas or advice? Cheers, R"
have a look at OXBALLS thats the one we have its good |
Reply privately, Reply in forum +quote
or View forums list | |
» Add a new message to this topic
