Do any one know anything about Prince Albert pearcings I had it done about a year ago I upsized from 2 mm thick to 3 mm thick with no problems but I cannot get a 4 mm one to go through at all tried lube with no luck any one know how to get it to go through? |
Reply privately, Reply in forum +quote
or View forums list | |
 |
By (user no longer on site)
over a year ago
|
"Do any one know anything about Prince Albert pearcings I had it done about a year ago I upsized from 2 mm thick to 3 mm thick with no problems but I cannot get a 4 mm one to go through at all tried lube with no luck any one know how to get it to go through?"
give it a good blow! |
Reply privately, Reply in forum +quote
or View forums list | |
|
By (user no longer on site)
over a year ago
|
"Do any one know anything about Prince Albert pearcings I had it done about a year ago I upsized from 2 mm thick to 3 mm thick with no problems but I cannot get a 4 mm one to go through at all tried lube with no luck any one know how to get it to go through?"
Try using a tapered insertion pin in either steel or acrylic. These can be bought in sets on ebay. The plastic ones are quite cheap and some go up to 10 or 12mm. Gently try sliding one through the existing hole a few times before you insert the larger jewellery. Bit of ky jelly on the pin to ease it through then follow the pin through with the new ring and Robert's your mothers brother  |
Reply privately, Reply in forum +quote
or View forums list | |
» Add a new message to this topic
